AquaLighter 1 Illumination Lamp User Manual Guide01 September 2016
Aqua Lighter 1 Illumination Lamp User ManualGuide
Intended Use and Speciﬁcations of the Product
The entryseries of AquaLighter 1 illumination lamps for freshwater aquariums is a universal solution for your aquarium. The movable feet of AquaLighter 1 illumination lamp allow using it on aquariums up to 100 cm long and wall thickness up to 12
mm. The illumination source of the AquaLighter 1 lamp are super-bright LEDs manufactured by OSRAM (Germany). Angleof light emission of LEDs provides more concentrated luminous ﬂux which enables to create enough light at the bottom of aquariums up to 45cm.
Aqua Lighter 1 Case Protection
AquaLighter 1 is supplied with ﬁttings which allow placing the lamp inside standard aquarium covers fast and easy, and can serveboth effectively as an additional illumination or a total substitution of aquarium lamp. AquaLighter 1 LED lampsseries has a patented technology to protect LEDs from moisture and water splashes by means of a bicomponent isolation material, which can keep a LED in a working condition even after a short time dip inwater.
Aqua Lighter 1 Safety Usage Rules
The deviceyou have purchased is manufactured in compliance with the norms applicable on the territory of Ukraine and European Union. For long lasting and safe usage, please do study the safety rules listed below:
- Voltagerating of the power supply system has to be exactly the same as the voltage rating indicated on the device.
- It isforbidden to use the device if the device or its electrical cord is damaged. It is recommended to check the condition of electrical cord each time before switching it on.
- It isforbidden to repair or change electrical cord, as well as install extra elements on it. If electrical cord of the device was damaged need to contact with technical support.
- Beforeyou switch on the illumination lamp, please make sure it is ﬁxed safely on the walls of aquarium or under aquarium cover.
Aqua Lighter 1 Preparation for Work:
Put on thefeet on the body of the illumination lamp. Place the lamp on an aquarium and
move the feet along the case of the device to the necessary extent. To mount
the lamp under aquarium cover ﬁx it with special ﬁttings (supplied). When you
make sure that the illumination lamp is ﬁxed safely on the walls of aquarium or
under aquarium cover, plug in the plug of the lamp into the socket of power
source. The device is ready to use.
Aqua Lighter 1 Maintenance
The devicedoes not require any special maintenance. If necessary, clean the body of the
illumination lamp from residues resting on it with the help of a soft tissue or
Dismantling and Utilization of Aqua Lighter 1
You cannotdispose of electrical appliances that are out of order into regular garbage.
Proper selection, collection and utilization of this type of waste will
contribute to preserving the valuable recourses of environment. User is held liable for delivery of theused equipment to the special collecting point, where it will be accepted free
Aqua Lighter 1 Warranty
Manufacturergives a warranty of 12 months since the purchase date. The warranty covers
damages that appeared due to the fault of manufacturer, i.e. material defects
etc. The warranty does not cover damages that appeared due to improper or
unintended use of illumination lamp. Attention! Any trials to change the structure of the device ordismantling of the device that fall out of the scope of regular intended use or
maintenance, lead to loss of warranty obligations. In case improper functioning
of the device is detected, need to contact with technical support. The warranty
shall be considered valid if the date of production indicated on the product
coincides with the date of production in the warranty paper. The present
warranty conditions do not exclude, limit or cease the rights of the buyer
granted by the applicable legislation of Ukraine and EU.